I have 4 sets almost ready. They are 4 of the 5 prototypes that I had made. I just need to finish the rest of the hardware and packaging.. Like I said, I am making a couple small changes. First is the filament guide tubes aren't staying in the pockets, they kind of wiggle out. I am going to make those taller by 3mm so they clamp in better. If the retooling costs aren't too much I am going to change the heat sink alignment a little, these aren't bad, just want to make them a little taller to give the mounting screws a little better access through the bottom fan holes.

The introductory price will be 80USD plus shipping. I'm not sure how long I will keep it at that price. These are expensive to make and right now wanting to try to recoup a portion of the tooling costs at least.