Results 1 to 10 of 255
Threaded View
-
11-10-2014, 10:34 AM #10
For ABS, I have varied between 90 and 110, but I didn't spend enough time with ABS to figure out the magic settings for the filament I have. What you're battling is figuring out what works best to hold the print to the print bed. Since ABS shrinks quite a bit when it cools, larger flat things will have a tendency for the corners to curl up and lift off the bed. The more airflow you have flowing around the print and the cooler your room temperature is, the more of a challenge you'll have with this. What you're using to cover the print surface (kapton tape, ABS slurry, etc.) is also a factor in how well the print holds. I think everyone has to figure these details out for their particular situation.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help