Results 1 to 3 of 3
Threaded View
-
11-09-2014, 10:59 PM #2
- Join Date
- Aug 2014
- Location
- Montreal, Quebec
- Posts
- 576
Well , yup, I did solved couple of issue because of this. Mine was caused from loose screw cause by constant vibration of the printer. I had the nozzle slightly off by a couple of mm which was enough to run into the print.
But that being said, you need to confirm where is the origin of the trouble. That will help you a lot.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion