I set-up ABL on a 10" i3v this morning with the firmware in the first post of this thread. My issues I'm running into so far are:

- My bed origin has always been on the rear right bed corner (with printer facing forward). Now when homing, after X and Y endstops are activated, the code probes toward the center of the bed for Z. How can I get it to probe in the same rear right corner as X and Y?

- Immediately after probing the center of the bed when homing, the servo retracts and rubs the bed. How can I get it to raise Z-axis a few mm before retracting the probe?

- When issuing a G29 for the ABL routine in Pronterface after homing, I get this error "echo:Home X/Y before Z".

I have googled a while for solutions, but the posted solutions I did find didnt work for any of the above issues.