Quote Originally Posted by Geoff View Post
The main thing you will need is this.. These should be the same as the ones I got, they are pretty cheap and nasty but they work.

Ramps9.jpg

Then just simply find the best prusa ramps tutorial you can find that speaks in your language, some are a bit over the top, some are just simple enough to follow without too much messing around.

And this is your wiring

NOTE

See the end stops in the image below have 3 wires, we are using 2 obviously. See there is Green, Orange Yellow? do not use the Yellow!

You only are using the 2 connections toward the edge of the board, the green and orange. This is important for zappy zappy puff of smoke reasons.
REPRAP schematic.jpg

Here is a good tutorial

http://www.danielhansen.net/2014/05/reprap-3d-printer-prusa-i3-build-log.html
​
You will need to also make sure the Z axis doesnt move too fast or the threaded rods will whirr away

Thankyou, I will get connectors and see how I go......