Results 1 to 10 of 172
Threaded View
-
11-06-2014, 01:52 PM #11
- Join Date
- Oct 2014
- Posts
- 114
I did this. No avail. I forgot to mention that where ever on the bed the stop switch is triggered, the x and y think they are home. So if I do a G29 then lift and do a G28, it will home fine, but if I hit G28 again, it will move from that x and y position. It's got to be something I am missing.
But again, it's the same fw that worked fine for month. Until I hit that z offset on the LCD.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion