Results 1 to 10 of 172
Threaded View
-
11-06-2014, 07:36 AM #11
- Join Date
- Oct 2014
- Posts
- 114
Thanks again Roxy,
I was able to get it back.
On another note. I have an issue on one machine since I changed the z offset on my viki lcd (this may not in anyway be related), but it is like that ever since.
I have the G28 deletion of plan bed leveling uncommented.
After g28 g29 the machine rests as it should in the far right corner. Now when I hit G28, it moves further back and right. Looks like it thinks it is home.
If I send a G x0y0 it goes to the home position, but it's not homeing (bouncing off the stops). If I lift z until the sensor goes out (I am using proximity sensors for z stop) it will home fine.
(It also homes fine if I don't do a G29 at all). Any ideas? I tried pretty much everything. It was working fine before.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help