Results 1 to 10 of 172
Threaded View
-
10-30-2014, 04:34 PM #2
I have printed omitting the G29 on the kossel, and to be honest for the few seconds it takes to perform the point check, I think I'll stick with it. I remove the glass plate alot so saving the g29 codes or re-using them might be bad for me on the kossel.
Hex3D - 3D Printing and Design http://www.hex3d.com
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help