Results 1 to 10 of 10
Thread: Help with Y-axis
-
10-29-2014, 07:24 PM #1
- Join Date
- Sep 2014
- Location
- Deer Park, TX
- Posts
- 62
Help with Y-axis
My 10" i3v has been working flawlessly since getting it running. Last night went to print and the y-axis wont move to the endstop during the G28 code; home all axis. It moves a few mils and then stops. I put a new end switch but still get the same results. The y-axis motor works fine in manual mode, I only get this problem when trying to print.
-
10-29-2014, 07:38 PM #2
- Join Date
- Sep 2014
- Location
- Deer Park, TX
- Posts
- 62
Ran a few test and noticed my z-axis is also off.
-
10-29-2014, 07:40 PM #3
- Join Date
- Sep 2014
- Location
- Deer Park, TX
- Posts
- 62
Tried reflashing firmware......no change.
-
10-30-2014, 09:57 AM #4
- Join Date
- Sep 2014
- Location
- Deer Park, TX
- Posts
- 62
I uploaded the original firmware to the printer and it works.....it seems the problem is with the Marlin auto bed level firmware. How could everything be working fine then it just stops working?
-
10-30-2014, 04:06 PM #5
- Join Date
- Sep 2014
- Location
- Deer Park, TX
- Posts
- 62
Anyone?? HEELLLOOO????
-
10-30-2014, 04:23 PM #6
- Join Date
- Jan 2014
- Posts
- 462
Not heard of that before. Did you find a source that said the problem was the auto bed levelling code?
-
10-30-2014, 04:54 PM #7
- Join Date
- Jun 2014
- Posts
- 74
Just a thought, but try commenting out the define for ABL using the code that doesn't work for you just to verify the problem lies in the ABL code. At least you will know for sure where to start troubleshooting. For me, trying to find a problem in the entire code base is daunting and anything I can do the be sure I've narrowed the search to right area of code is helpful.
-
10-30-2014, 06:18 PM #8
- Join Date
- Sep 2014
- Location
- Deer Park, TX
- Posts
- 62
The problem is in the firmware...not the hardware. When I upload the old firmware without the ABL it works fine. Its weird cause Ive been using it for many weeks now without any problem. Then out of nowhere this problem arises. When I enter G28 code, the Y axis only moves a few mils, not all the way to the endstop. I just dont get it. even when I reflash with the saved ABL code that I originally used....it does the exact same thing. What could cause the code to change while its flashed onto the Arduino board? I dont even know where to start with this problem.
-
10-30-2014, 06:45 PM #9
- Join Date
- Sep 2014
- Location
- Deer Park, TX
- Posts
- 62
Problem Solved!! One of the wires broke off from the Z endstop switch. Not sure why it affected the y axis.
-
10-30-2014, 11:05 PM #10
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help