Close



Results 1 to 3 of 3
  1. #1
    Student tawnos76's Avatar
    Join Date
    Feb 2014
    Location
    Chino, CA
    Posts
    2

    Heated build plate not holding temp

    I just upgraded my Replicator 2 to have a heated build plate. When I run any model after preheating the HBP just starts dropping and will not keep any heat.

    I upgraded to sailfish and still have the same problem.

    Should I change my makerware profile to Replicator 2x so I can set the plate to on or is there something else that needs done.
    thank you

  2. #2
    Student tawnos76's Avatar
    Join Date
    Feb 2014
    Location
    Chino, CA
    Posts
    2
    fixed with a edited .json file

  3. #3
    Staff Engineer old man emu's Avatar
    Join Date
    Oct 2013
    Location
    Narellan, New South Wales, Australia
    Posts
    912
    Well done! Welcome to Problem Solving for 3D Printers 101.

    There are no major problems. Most times the answer is hiding somewhere.

    Old Man Emu

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •