Results 1 to 10 of 10
Threaded View
-
10-28-2014, 01:00 AM #7
From the article: " a shaft printed in a vertical orientation with many small round layers would be easy to snap, but the same part printed in a horizontal orientation with a few long layers would significantly less brittle." I know that w:hen I printed this it separated very easily and looked like a slinky.
If I was to rotate the object 90 degrees to lay it on its side, how would I get the cylindrical shape?
OME
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion