Results 1 to 4 of 4
-
12-08-2013, 02:40 PM #1
- Join Date
- Nov 2013
- Location
- Haram, Giza, Egypt
- Posts
- 22
Electronics problem: Thermocouple reading on RAMPS 1.4
Hi there RepRappers
it looks like I've bought an MK8 extruder for my 3D printer but I found that the temperature sensor is a thermocouple and not a thermistor !!
my electronics are:
Arduino Mega 2560
RAMPS 1.4
I figured out that RAMPS 1.4 doesn't read thermocouple !!
does this problem have a solution ??
NOTE: I use sprinter and repetier firmwares.
SAM_0134.jpg
-
12-08-2013, 10:19 PM #2
- Join Date
- Oct 2013
- Location
- new jersey
- Posts
- 752
sure get a thermistor and either mount it in the block if there is a hole for it. if not and even a more accurate way is to take 1/4" kapton and tape it to the side of the nozzle. wrap the kapton tight. i use marlin and it has a PID auto tune feature. if your firmware has that then run it.
-
12-09-2013, 07:21 AM #3
- Join Date
- Nov 2013
- Location
- Haram, Giza, Egypt
- Posts
- 22
that's not what I meant, I meant that RAMPS 1.4 doesn't read from a thermocouple !! ... but I searched for it and found that it needs an extra module "thermocouple amplifier".
the most famous are AD595 op-amp circuit and MAX xxx something !!
I will build my own amplifier and connect it between my thermocouple and RAMPS 1.4
I found solutions there:
solution
reference RepRap Wiki
-
12-30-2013, 02:43 PM #4
You're both right.
If you want to use the thermocouple, you'll need the amplifier to bring the signal up to a stable and readable level.
If you don't want to deal with the extra circuitry, though, you can certainly leave the thermocouple disconnected and install a thermistor, for standard operation.
Personally, I don't have the experience with 3D printers to make a call on this, but from an electronics standpoint, the fewer circuits and signal modifiers you have, then easier it is to setup and troubleshoot.
I don't recognize your printhead, so I'm not familiar with the layout. Would it be possible to remove the thermocouple and install a thermistor in its place?
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery