Results 1 to 9 of 9
Thread: First print that didn't stick
Threaded View
-
10-24-2014, 05:44 AM #3
Clean the bed
re-calibrate
Change to makerware
try again :-)
I can't honestly think of a less user friendly piece of software than rep-g. Also it's glacially slow in slicing. And the raft sucks and is a bugger to remove. And it has generally all round crap-ness.
Makerware wise - don't get the latest desktop. That's almost as bad as repg.
You want the older makerware.
Actually you want simplify3d - but start with makerware.
Hmm, someone might have to upload a version to this forum - seems to have disappeared from the makerbot website. Bastards lolLast edited by curious aardvark; 10-24-2014 at 05:55 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion