Results 1 to 10 of 11
Threaded View
-
10-20-2014, 02:05 PM #10
- Join Date
- Oct 2014
- Location
- Redwood City
- Posts
- 26
Please post a link to the review. I cannot find any Shaxon filament on Amazon so until you provide a link I am calling you out. I know this is my first post here and I could be anyone, but I have 4 rolls of this filament, 3 ABS(black, florescent green, red) and one of PLA. All 3 rolls of the ABS have had nominal diameter variances, and the PLA was more consistent then the Makerbot PLA for the first half of the roll until I hit one large spot that looked like a kink from when they were spooling it. I do get filament bits like the picture above but only when the hobbed bolt slips and digs a hole in the filament after my spool holder gets stuck.
I have to say for 25 dollar filament this is well worth the money.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help