Results 1 to 10 of 57
Threaded View
-
10-19-2014, 01:35 PM #33
- Join Date
- Oct 2014
- Posts
- 7
John,
I disagree. I read your post in the email alert and found it to be very helpful. It would be a good post for anyone just getting started. This is an incredible forum and appreciate the great advice. I bought my FF last week to print a prosthetic hand for my son. Until I found this forum I wasn't sure I'd ever figure it out to the point where we could start printing his hand. We're going to spend a couple weeks playing around with materials and settings before we try the hand. I'm thinking about starting a new Thread to show our progress with the "Hand Project" and solicit advice. Do you think that would be an appropriate use of this forum? Thanks!
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion