Results 1 to 10 of 69
Threaded View
-
10-10-2014, 07:47 AM #25
Ok if it is lifting straight away, we have a bed level issue, not an ABS issue. If you have the bed at 110c, the ABS should no matter what, be sticking well for at least the first 10-20 layers or so
If you have Blue tape, here is a good trick to get you going..
Add another layer of blue tape on top of whatever you have there, so you have 2 layers... heat the bed to 112c when you print, you will see a big difference. The extra tape saves you re-levelling the bed also, its a band aid fix but tells you if you are on the right track or not.Hex3D - 3D Printing and Design http://www.hex3d.com
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion