Results 1 to 10 of 112
Threaded View
-
10-09-2014, 11:48 AM #3
Ah that would work - because the initial outline it prints clears the nozzle anyway.
Well currently printing another plug at 0.3 and it didn't curl !
I can see that it's adding infill at the edger of each layer - which makerware doesn't do. I think that's what's keeping it from curling.
So far I'm impressed :-)
And i remember someone replacing that purge code with the code makerware uses to draw the line on the edge of the bed.
Think that was on the simplify3d forum.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help