Results 1 to 5 of 5
-
10-09-2014, 09:49 AM #1
HELP! Flashforge Creator Pro won't turn on
1. Installed extruder.
2. Installed power cable.
3. Flipped switch, noting.
I've tried changing a few power cables, a few different wall sockets. nothing.
Are there something I'm missing?
-
10-09-2014, 10:03 AM #2
Hm, when I tilted it over to a side to se if the PSU fan was running it suddenly started up. Might just be a bad connection somewhere.
-
10-09-2014, 10:28 PM #3Hex3D - 3D Printing and Design http://www.hex3d.com
-
10-10-2014, 12:06 AM #4
-
10-10-2014, 05:53 AM #5
and be careful.
I had a pc in for repair a few years back that worked lying flat but not standing up.
So I stood itup, went off, laid it flat started up. Did this a few times for novelty and then it blew up !
Huge spark, big bang, lots of smoke - I nearly wet myself.
Bloody psu had a loose capacitor - one of the big ones. It had been rocking on it's contact and eventually decided it had had enough and just exploded.
So just be careful :-)
Hopefully it's just a loose wire.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help