Results 1 to 10 of 112
Threaded View
-
10-09-2014, 09:32 AM #2
Yes, the plastic spitting is annoying. Because I have had cases where it curls upwards and becomes a clog in front of the nozzle (I didn't check it) and a few minutes into the print I had created just a big ball of PLA.
For some reason it doesn't do this when I'm printing in ABS. Will compare my ABS and PLA profiles when I get home.
But for now; I don't know how to turn this off. Probably in one of those advanced tabs,, but that's too advanced for me.
EDIT:
There's this in the Starting G-Code:
G1 E25 F300 ; purge nozzle
I assume you can just delete that line (going to test that now)Last edited by Dargonfly; 10-09-2014 at 11:05 AM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion