Results 1 to 3 of 3
-
09-27-2014, 01:29 PM #1
Makerbot thinks Home position is off to the Right
Hi,
I just got a 5th gen Makerbot replicator and every time I try and level the build plate the or when I start a print, the extruder will move to the far right of the build plate and start to try and print there. I have power cycled, reset defaults, upgraded firmware and moved the head manually to different places (while turned off). I'm pretty much at a loss as to what is going on.
Any Ideas?
-
10-06-2014, 01:34 PM #2
- Join Date
- Oct 2014
- Posts
- 7
Try updating the firmware, there has been a lot of updates since release
-
10-06-2014, 03:48 PM #3
take it back and get a gen 2.
By what I've heard about the 5th gens - you'll be a lot happier with an earlier model.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion