Results 1 to 10 of 28
Thread: The twisted rook
Threaded View
-
10-06-2014, 12:43 PM #7
The .2 mm is better
I printed the 0.1 too slow I think.
here they are with a standard size marvin - the rooks are 35.6mm high.
The 0.2mm one - the other one is the same but rougher.
Not up to form one detail - but probably better than the peachy ;-)
All the details is there - just needs arctic quality cooling.
But I love this pla stuff - my only complaint is that it sticks too much to the blue tape lol
I might have to try the 3dp windup again :-)
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion