Results 1 to 10 of 17
Thread: Well there's ya problem!
Threaded View
-
10-06-2014, 01:30 AM #2
Yep, grab that hobby knife and clear the gunk out. If you ever wear a groove in the gears, just loosen it and move it up a bit and use a nice clean section of the hobbed gear, it's like getting a new one!
I am yet to get simplify3d working, it runs and closes straight away without even bringing up the splash screen.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion