In fill

[KenR60]

I'm wanting to do a large Number ( 2 ) that's about 3cm thick. I don't want it solid so will use maybe a 10% Infill? So is there a way of knowing what thickness the sides/top or bottom will be?

[RAMTechRob]

You have to set your shells. Probably one shell will be good enough if you just want it for show.

[KenR60]

Excellent, thank you for that, I will test it out today

[old man emu]

I'm wanting to do a large Number ( 2 ) that's about 3cm thick.

Any more of this toilet talk and you'll be taken out and beaten to within an inch of your life with a toilet bowl brush!

Old Man Emu

[KenR60]

LOL Yeah I should have picked a 3 instead

[Mjolinor]

Any more of this toilet talk and you'll be taken out and beaten to within an inch of your life with a toilet bowl brush!

Old Man Emu

Will you wear a wet suit and can I watch please?

[old man emu]

Will you wear a wet suit and can I watch please?

Trust a Public School boy to enjoy a good beating!

OME

(I was going to make a reference to fagging and fags, but out American friends would not understand the connotation!)

[3dkarma]

Bumming a fag is a very different experience in the US cf the UK / Aus.

[Geoff]

Bumming a fag is a very different experience in the US cf the UK / Aus.

Yeah, pretty common term here, not something you really blink twice at reminds me of these candies/lollies we used to have here called 'Fags' , imported from the U.S or mexico I think.... they were fake cigarette candies.. they changed the name to 'Fads' (which is sorta still applicable lol...)

I wanted to get this thread on track, so I re-read the first post again.. "I'm wanting to do a large Number ( 2 ) that's about 3cm thick."

and all I could do was burst into laughter, sorry, I will be no use here...

[3dkarma]

reminds me of these candies/lollies we used to have here called 'Fags' , imported from the U.S or mexico I think.... they were fake cigarette candies

I remember fags in Australia - they had a red tip on them. I always preferred the cigars, though. You had to remember to take the gold foil band off otherwise you'd get a nasty shock halfway through.

Enough nostalgia. Wall width is the vertical shells perimeters setting in Slic3r under Print Settings / Layers and perimeters. Top and bottom are in the Horizontal shells part of the same settings section.