Results 1 to 8 of 8
Threaded View
-
09-28-2014, 03:40 AM #7
There is a link to this document in the Profitweak app.
http://www.makerbot.com/support/make...tation/slicer/
It doesn't say what to do with each setting, just what each does. I'd say 80% of it I don't mess with much. The other 20% are layer settings, temps, speeds, filament density and thickness, and I adjust the support angle, distance and density. There are some useful dynamic speed settings that help with corner rings if you are printing fast. The dynamic speed settings slow down the extruder when it comes up to a corner.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion