Results 1 to 10 of 396
Threaded View
-
09-24-2014, 09:21 PM #10
- Join Date
- Sep 2014
- Posts
- 12
Something else to look at in the configuration.h, right about that line it says :
//If defined, the Probe servo will be turned on only during movement and then turned off to avoid jerk
//The value is the delay to turn the servo off after powered on - depends on the servo speed; 300ms is good value, but you can try lower it.
// You MUST HAVE the SERVO_ENDSTOPS defined to use here a value higher than zero otherwise your code will not compile.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help