I have been frustrated with having to dig through lots of places to get all the bits and pieces for the most recent code for the Marlin firmware for the i3v. I also note that the trunk is slow to incorporate pulls.
So, I have setup a fork of the Marlin trunk with the Type 6 therm. table modified, auto bed leveling enabled (this is easy to turn off) and Roxy's enhanced G29 (and G28) commands with the debugging info on. For a better description of the therm table stuff, see this
post.
I am trying to keep this current against the Marlin trunk, e.g. it includes the 9/14 fix for the vector calculations and the fixes for the defines related to the sleds.
Here is the repo:
https://github.com/beckdac/Marlin
Make sure you update your E-steps and set the ABL servo angle before using!
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help