Results 1 to 2 of 2
-
09-22-2014, 01:29 AM #1
QU-BD Two-Up Printer Board Problems
It's me again; it seems I cant go twenty-four hours without encountering a new problem.
I plugged in my board for the first time and immediately got a red status LED on the printerboard :/
Repetier (nor my computer) won't identify the printer, and thus it won't connect to the printer (its searching for COM port 4).
I've submitted a support ticket to QU-BD, but God knows how long it will take them to get back to me
Any suggestions?
Thanks!
-Apollo
-
09-22-2014, 03:49 AM #2
This could go all the way back to the set up of your Printrboard board, which has the firmware installed on it. Look at http://reprap.org/wiki/Printrboard
Note: Refer to the board as Printrboard which is spelled without the 'e'.
OMELast edited by old man emu; 09-22-2014 at 03:55 AM.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help