Results 1 to 10 of 47
Threaded View
-
09-18-2014, 12:12 PM #40
it's abs so - heated bed.
I'm not going to be printing organic models very often. So I can happily live with that. The 24v fan might shift more air - should be here by the weekend.
I did print out a model dimpled glande (ancient slinging bullet crossed with modern aerodynamics) with a much smaller initial 'footprint'. And that was damn near perfect.
I've got a roll of pla I haven't really used - so might see if that's any better. Plus I need to try the nylon again.
Not to mention the dual extruder printing thing. And making some bed clips and moving the on/off switch to the front...
This is not a hobby that'll grow stale in the forseeable future :-)
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help