Just got my Flashforge Creator Dual and here are my first prints

[curious aardvark]

So did the sphere work ? I'd be amazed if it did.

I got the fan working and it was going well when the computer died. Need new psu - and I was busy thereafter with other things.
I'll change psu's and try again later :-)

But I did discover one drawback to the ducting adaptor. Bloody thing hits the bulldog clips. So now I'll have to figure out a system to hold the aluminium plate in place that's super low profile.

The little bit of sphere I printed yestreday before the power went - was a huge improvement. So it's definitely working :-)

Far as the nylon goes - it was christmas present, so no idea where it came from.

but 3dfilaprint do the nylon bridge at a reasonable price. And that's supposed to be a lot easier to use than the 618 I've got.
http://www.shop.3dfilaprint.com/bridge-70-c.asp
Cheaper than any I've seen on ebay. And avoid the ebay stuff that just says 'nylon' without any other description. I'm not saying it's all garden strimmer line - but it's probably closer to that than to the taulman stuff :-)