Results 1 to 10 of 27
Threaded View
-
09-12-2014, 01:38 PM #7
- Join Date
- Jul 2014
- Location
- Munich
- Posts
- 45
first sorry for so long no news but I was a bit busy so no time to go on, additional I have a small issu with the transfer of the pic to the computer
I hope to solve the issue with the pics tommorow han can give you a lot of new views.
What I did today was uploard the firmware and check the first points
so far thermistor headbed and the heatbed themselve are working
with my ground adjustement of the Polols Z is working good so far only a seldom sound is hearable but this could be also bec the spindles are dry at the moment this will check later.
after readjust my Y belts this is also working.
X was making trouble but after a while ( sitting in front and not understanding anything anymore ) i get it , stupid issue from my side I connected the motors like i do usual but here the motors need to run in opposide directions ,
after the connector was turned the X is now also moving.
I´ll sit don now I try to finish the Hotend (thermistor and heater not connected yet)
Will update tomorrow plan would be to finish all and start calibration.
br
Thomas
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion