Results 1 to 6 of 6
Threaded View
-
09-09-2014, 11:21 AM #3
- Join Date
- Jul 2014
- Location
- Ontario, Canada
- Posts
- 257
That's a good point. I've run the all metal extruder on my printrbot for the last 6 months, and with a properly tuned stepper, the heat hasn't been much of an issue on longer prints (6 hours or so) I would probably run some of the cork insulators between the extruder and the stepper, and if need be, switch out the MakerFarm stepper with a printrbot stepper (as they seem to run a bit cooler) As it is, my current stepper on my MakerFarm hasn't gotten too warm, certainly within acceptable limits (after tweaking the stepper pot of course)
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion