Results 1 to 10 of 71
Thread: MakerFarm 10" i3v build
Threaded View
-
09-03-2014, 11:26 PM #11
The pot holder thing seems to be working fine, although I unintentionally ended up with a pretty good air gap under the heat bed too. I adjust all four corners of the bed now, and I'll bring the bed down a bit the next time I'm adjusting the Z endstop. 10 degrees seems like a pretty hefty temperature drop. The 10-inch comes with a heat bed relay; I'd probably start by measuring the voltage at the output of the relay and seeing how much it changes when you see the temperature drop. That might at least eliminate concerns that the power supply is dropping or that the wire gauge to the relay is too small.
Seems like a smart move on the kapton under the edges of the heater circuit board. I haven't had things apart enough to install it yet.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion