Nope. I have LEDs mounted under the carriage and had glued-up the X-carriage prior to painting so for now I'm stuck. To clean mine up, I just turned on the heater and wiped it off carefully as the block got hot.
Again, this is great information. I actually copied your approach for the LED strips under the X-carriage, but haven't wired them up yet. I'm thinking of putting them on D9 (IIRC) of the RAMPS board so they only run during the print process.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion