Results 1 to 10 of 71
Thread: MakerFarm 10" i3v build
Threaded View
-
09-03-2014, 12:42 PM #2
Idler:
WP_20140901_012.jpg
Feet (though I haven't bothered to install them as I have no vibration issues):
WP_20140901_028.jpg
And replacement extruder parts.
WP_20140901_022.jpgWP_20140902_002.jpg
Now, I have switched over the ABS (the glow in the dark green above) and started using Cura for everything. I don't like ABS nearly as much as the PLA. PLA just worked and didn't curl, etc. With the ABS, it sticks well to the blue painters tape, but on large prints (e.g. the Tie Fighter for the boys), the edges would warp and pull the painters tape off the glass.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion