Results 1 to 6 of 6
Thread: marlin 1.4 for makerfarm i3v 10"
-
08-28-2014, 12:55 AM #1
- Join Date
- Aug 2014
- Posts
- 25
marlin 1.4 for makerfarm i3v 10"
Is anybody using marlin 1.4 on there 10" i3v? I want to add auto bed leveling but i have been informed that Marlon 1.4 might cause issue with i3v.
-
08-28-2014, 09:15 AM #2
I don't think you should be hesitant of switching over... First, you can always reload the existing firmware if there are problems. But the newer Marlin firmware is very solid and not too hard to get going if you have people you can ask questions. (And you do have that....)
-
08-29-2014, 07:50 AM #3
- Join Date
- Aug 2014
- Posts
- 5
Im also looking into this atm, ive only had my printer 2 weeks and the leveling of it every time is driving me crazy
-
08-29-2014, 08:55 AM #4
- Join Date
- Aug 2014
- Posts
- 25
i added this to my z endstop. makes it much easier to get the hot end right were you want it.
http://www.thingiverse.com/thing:437330
-
08-30-2014, 04:54 AM #5
- Join Date
- Aug 2014
- Posts
- 5
nefiwashere - Ive just got it going on mine. i'll be doing a test print tomorrow.
-
11-26-2014, 08:12 AM #6
- Join Date
- Aug 2014
- Posts
- 25
Having an issue with printing @.1
Have abl setup with new Prometheus hot end.
This is my first print with this hotend. Have always used the hexagon hotend with very good results but I always printed at .3
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion