Results 1 to 10 of 189
Thread: Show your MODS
Threaded View
-
08-23-2014, 03:30 PM #6
- Join Date
- Jul 2014
- Location
- Eastern Colorado
- Posts
- 536
I think I may have figured out the problem with this, though I haven't tested it yet. I installed the T nuts as demonstrated in the MakerFarm assembly videos, with the raised threaded part up. I noticed that this threaded part was coming in contact with Clough42's brackets, keeping them loose on the extrusion even though the screws were impossibly tight. I think if I flip the T nuts over, it may work as intended.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion