Results 1 to 10 of 13
Thread: Ultimaker 1 Warping Problems
Threaded View
-
08-21-2014, 11:05 AM #2
wait, you are printing at 220mm/s?? if thats your speed, wicht it sounds crazy thats too fast, go lower meabe 100 mm/s or 50 that should do the trick, also if you can reduce the speed at wicht your base (first 5 layers) are been print do it, the more stability you have on your base the less headaches you will have later.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion