Quote Originally Posted by roykirk View Post
No go. Corners still warping up. Giving up on the duel extrusion, clamping down the bed, and going back to Rep G. Will try dialing the bed temp back down to 50c as well. Fall back to what worked before and go from there I guess. I'm thinking I might need one of those infrared heat guns from the hardware store as well. The bed temp could be way off from the old printer as well.
I have never used a glass plate for dual extrusion raftless prints, so that is an unnacceptable reason to give up!

I'll be honest, if you have done 1000 hours in your old flashforge, troubleshooting this shouldn't be much different .. 50c on a heatbed is about the same as not heating your bed, you might as well turn it off.