Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 18

Threaded View

  1. 08-18-2014, 09:31 AM #16
    printbus
    printbus is offline
    Staff Engineer printbus's Avatar
    Join Date
    May 2014
    Location
    Highlands Ranch, Colorado USA
    Posts
    1,437
    Add printbus on Thingiverse
    Quote Originally Posted by TopJimmyCooks View Post
    Observations: the stock makerfarm slicer settings came with max 60mm/s for infill and 130 for travel. Obviously a lot slower than Clough42 is tuning to.
    These are the default values built into the Slic3r software. You're not running with the MakerFarm config files unless you manually load them. I assume you haven't been doing this?
    Last edited by printbus; 08-18-2014 at 10:03 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules