Results 1 to 10 of 18
Thread: Command Line Communication
Threaded View
-
08-15-2014, 09:56 PM #1
- Join Date
- Jun 2014
- Location
- Australia
- Posts
- 18
Command Line Communication
Do any of you know any methods to communicate to the FF Creator X via the command line; I want to send jog/move commands like printer.moveX(100) - or something like that.
I've only had luck communicating with the printer (USB) using ReplicatorG or Makerware. I've tried Repetier Host, Printrun, Cura and MatterControl, but cannot connect (at any baud rate). From what I've read, the FF (or essentially the Makerbot) can only communicate with software that supports x3g.
Is there any method I can use to send commands or connect with any g-code software, maybe by using GPX to convert it first?
(My firmware is Sailfish 7.6 (r1228))
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion