Results 1 to 10 of 39
Threaded View
-
08-15-2014, 05:21 AM #3
Thank you for your reply. I have seen your models before on this board, good stuff, the Gremlin head made me relive a lot of nightmares ...
Is that a Prusa that you use for these models? Which material do you print in? Do you have to do any finishing on your models before painting? You don't use any vapor-bathing, filling, or additional putty modeling I think, or do you?
Are there any printers that you are aware of that produce higher quality prints then yours? Not saying that yours aren't good, but realistically there is always something better.
I would not mind spending a lot more money for even the tiniest increase in quality. Every bit of quality that the printer adds saves me post-processing work.
Or do you have any experience with the printers that I listed?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help