Results 1 to 10 of 39
Thread: Auto leveling
Threaded View
-
08-13-2014, 08:44 AM #38
I know my PrintrBoard could not supply the power to the servo. I had to grab a 5v line off of my ATX Power Supply and feed that to the servo. I was so confused until I figured that out. I could move the servo around but only in small steps. Big steps would reset the PrintrBoard. To verify I even made changes where it would only modify the position of the servo by 5 degrees at a time and then pause to keep the initial surge current low. That would work and I could position the servo accurately. I just could not do it in one big quick step.
Then.... Everything made sense!Last edited by Roxy; 08-13-2014 at 09:52 AM.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion