Results 1 to 10 of 189
Thread: Show your MODS
Threaded View
-
08-10-2014, 10:52 PM #11
RAMPS Cooling Fam
I added a 40mm fan to the RAMPS board to keep the drivers and especially the heat bed transistor cool. The heat sink on the transistor was getting warmer than I liked and I think I was having trouble with the bed getting to temperature. I'm not sure if it was a real problem or not, but since I added the fan, it's been fine.
I didn't design the fan mount. I used this one: http://www.thingiverse.com/thing:49235
2014-08-10 21.38.09-resized.jpg
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion