Results 1 to 10 of 26
Thread: Nylon Filament
Threaded View
-
08-07-2014, 10:58 PM #23
Well... OK, but I can tell you I would put an extra nut on each side and lock both pairs down hard. I don't care if they don't like it! The whole purpose they are there is to make sure the bearing (which is also the pulley???) doesn't move. I'm going to spend the extra $.18 and lock the position down hard. (And I can still move it later if I decide to. ) {But I also know your printers are better than mine... So I won't lecture you!}
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help