Results 1 to 10 of 757
Hybrid View
-
07-30-2014, 07:27 PM #1
- Join Date
- Jul 2014
- Location
- Eastern Colorado
- Posts
- 536
Yes. Y axis homes, gets set to 0, then while Z axis moves before extending the probe, Y axis also moves, about 10mm, but stays set at 0. So Y axis coordinates are offset by 10mm after a G28, before G29. That's why, when doing the last row of levelling probes during a G29, the probe is right on the edge of the glass (197mm) while the LCD reports it at 187mm.
Last edited by AbuMaia; 07-30-2014 at 07:29 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion