Results 1 to 10 of 10
Threaded View
-
07-29-2014, 02:38 PM #9
- Join Date
- May 2014
- Posts
- 4
Ditto to all above. I would add if you are using slicr go to printer settings and tweak the Z-Offset a business card is approx .33mm so without going over this amount, be careful, I have no way of knowing your actual settings so err on the side of caution! I would start with (-.15) to (-.25)mm get a calibration stl I use a 20X20X10 mm box and keep adjusting the z offset till you get consistent results. goog luck
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help