Results 1 to 10 of 757
Threaded View
-
07-27-2014, 07:33 PM #10
- Join Date
- Jul 2014
- Location
- Eastern Colorado
- Posts
- 536
I don't think I'll be using the safe homing. I just tested, and found a G29 after a G28 puts both Y and X 10mm off. I have to send both Y and X 10mm negative to get back to the endstops once the bed leveling is finished.
Nevermind, that's not because of safe homing. It's now the same even with safe homing off.
Double nevermind, it was because I had the Left Probe Bed Position set smaller than the X probe offset.Last edited by AbuMaia; 07-27-2014 at 07:49 PM.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help