Auto_Bed_Leveling: Enhanced G29 command

[Roxy]

Tell you what.... How about we turn on 'Safe Bed Leveling' until we get this figured out. The reason is, I've always had that enabled and I'm more familiar with how things move in that mode. Once we figure out what is going on, we can turn the 'Safe Bed Leveling' off. Would that work for you?

And we don't need to worry about it now... But I suspect you want to set the Topology Map to having the Origin at Back Right. The reason is you can just visually map what it prints out on to the print bed and know which corner is high or low or where you have high or low spots on your bed.