Results 1 to 10 of 10
Thread: Flashforge Filament super Fail
Threaded View
-
07-25-2014, 07:26 PM #3
To transfer it to another roll impossible - as I said every 5-10 revolutions it would split and tangle, to swap rolls would have taken more time that it was worth! also once these are split, you get filament falling through the cracks, literally needs complete dismantling.
you also will notice they are all steering clear of this thread
That's ok, check the view count on the Flashforge forum versus the other manufacturers I'm sure someone will get the message.Last edited by Geoff; 07-28-2014 at 12:49 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion