Wanhao Duplicator 3

[Mjolinor]

Temperature was 230. Firmware version was 7.2 but is now 7.7 Sailfish and it is slightly better with the newer firmware.

Quite hard to say from a picture though. 7.7 on left, 7.2 on right.

It gets better if I pause on each layer but it is obvious that I have not got the chamber hot enough yet, it is about 55c and it needs to be somewhere near 70, you can see that from the steps on the edge every two layers. Once I get to 70 I will disable the heated bed as it will not be needed and I will use that input and output for the chamber temperature.